The following commands to change parameters are found on the Video Monitoring Software Program Administration web page under the heading, Program Settings.
Enable Capture(0,1)
Enter 0 enables capture.
Enter 1 disables capture.
Set Compressor(0,30)
Enter the compressor you would like to use. Recommend MS MPEG-4 V1. Takes effect only if save configuration, and re-start the application.
Set Min Disk Space(4M-2GB)
Specifies that if free disk space falls below this value, then the Video Monitoring Software program will stop recording video to file. Range 4000000-2000000000.
Set Frames Per File(2-323K)
Sets how many frames will be stored per video file. The more the larger the file. The larger the file the longer the period of time it covers. The longer the file the longer it takes to download to your remote location over the web. If slow remote connection keep the files small, 50 frames. ADSL 1000 frames per file OK. Remember to use a good compressor to save disk space. Range 2-1000000.
Enable Upload IP(0,1)If set to 1, causes program to upload it's IP address to a remote server so the program can be found on the Internet. If set to 0, no IP address is uploaded.